About Us | Product Line | Artica Range | Paper Glossary | News Letter

Produuct Line » Amtronics » POLAQUA 103-L »
  POLAQUA 103-L
Water Based Primer
Polaqua 103-L is an extrusion, lamination and printing primer for use on many grades of polypropylene and other films. It exhibits grease, oil and moisture resistant bonds strengths with onky minute applicaion levels. Application is proportionate to one gallon of Polaqua 103-L for approximately 20 reams (60,000 Ft²) of substrate.

Polaqua 103-L is applied to the film surface and dried. For best results, especially with certain grades of polypropylene, it is recommended to have the acccepting surface corona treated. The extrudate, lamination or printing inks will then rigorously bond to the primed surface by heat and pressure application.
TYPICAL PROPERTIES CHARACTERISTICS
Appearance Hazy Liquid
Solids 2%
Wt./Gal. 8.35 lbs
pH 9.6
Sp. Gravity 1.0024
Freeze Thaw 4 Cycles
Stability Full Range
Visocity Brookfield - 4 cps
77 ° F. Zahn 2- 16 sec
Non-Toxic
Non-Flammable
Non-Corrosive
Water-Based
Long Shelf Life
USES
Extrusion Primer
Lamination
Printing Ink Primer


COMPATIBLE COMBINATIONS
LDPE-Surlyn-Printing Inks to accepting substrates:
Polyester, Polypropylene, Nylon, Cellophane, Vinyl, PVDC, Aclar, Aluminum Foil, Polycarbonate, Paper and Board.

APPLYING CONDITIONS

Room temperature 50 Deg F and up.
Solution temperature 33 Deg to 170 Deg F.
Pick-Up Roller - Smooth or Gravue 200 line and up.
Squeeze Roller - Hard Rubber 80 to 90 durometer.
Accepting surface should be corona treated for best results.
Primed surface must be thoroughly and absoluetly dry before web is introduced to lamination, extrusion or printing.

Polaqua 103-L as with all Polaqua systems is water-based and formulated from ingredients found on FDA lists cleared for food packaging.
Copyright © 2007 Sudhir Paper Limited. All Rights Reserved
Disclaimer | webmaster@indiapaper.com
 By: Techweb